Subaru Legacy 2003 Service Manual page 1676

9. Engine Assembly
A: REMOVAL
1) Set the vehicle on lift arms.
2) Open the front hood fully, and then support with
the hood stay.
3) Collect the refrigerant from A/C system. <Ref. to
AC-23, Refrigerant Recovery Procedure.>
4) Release the fuel pressure.
(1) Disconnect the fuel pump relay (A) connec-
tor.
( A )
(2) Start the engine, and run until stalls.
(3) After the engine stalls, crank it for 5 seconds
more.
(4) Turn the ignition switch to OFF.
5) Remove the filler cap.
6) Disconnect the ground cable from battery.
7) Remove the radiator from vehicle.
<Ref. to CO(H4DOSTC)-23, REMOVAL, Radia-
tor.>
8) Remove the coolant filler tank.
<Ref. to CO(H4DOSTC)-33, REMOVAL, Coolant
Filler Tank.>
ENGINE ASSEMBLY
9) Disconnect the A/C pressure hoses from A/C
compressor.
10) Remove
IN(H4DOSTC)-13, REMOVAL, Intercooler.>
11) Disconnect the following connectors and cable.
(1) Engine harness connector
FU-00648
(2) Engine ground terminal
FU-00009
(3) Engine harness connector
ME(H4DOSTC)-31
MECHANICAL
ME-00625
the intercooler.
ME-00626
ME-00028
ME-00627
<Ref. to