Subaru Legacy 2003 Service Manual page 2101

CONTROL SYSTEMS
3. Select Cable
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect negative cable from battery.
3) Prior to removal, set lever to "N" position.
4) Lift-up the vehicle.
5) Remove front, center, rear exhaust pipe and
muffler. (Non-turbo model)
2.0 L and 2.5 L with OBD models
<Ref. to EX(H4SO)-5, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H4SO)-9, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SO)-10, RE-
MOVAL, Muffler.>
2.0 L and 2.5 L without OBD models
<Ref. to EX(H4SOw/oOBD)-9, REMOVAL, Front
Exhaust Pipe.>, <Ref. to EX(H4SOw/oOBD)-13,
REMOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(H4SOw/oOBD)-14, REMOVAL, Muffler.>
3.0 L model
<Ref. to EX(H6DO)-5, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H6DO)-8, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H6DO)-9, RE-
MOVAL, Muffler.>
6) Remove center and rear exhaust pipes and muf-
fler. (Turbo model)
<Ref. to EX(H4DOSTC)-7, REMOVAL, Center Ex-
haust Pipe.>, <Ref. to EX(H4DOSTC)-12, RE-
MOVAL, Rear Exhaust Pipe.> and <Ref. to
EX(H4DOSTC)-13, REMOVAL, Muffler.>
7) Remove heat shield cover. (If equipped)
SELECT CABLE
8) Remove snap pin and washer from range select
lever.
9) Remove plate assembly from transmission
case.
10) Disconnect cable from select lever and then re-
move cable bracket.
AT-00682
11) Remove select cable from plate assembly.
CS-12
( A )
( D )
( C ) ( E )
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Clamp
(E) Washer
( A )
( C )
( B )
(A) Select cable
(B) Plate ASSY
(C) Clamp
( B )
(A) Adjusting nuts
(B) Cable bracket
( B )
CS-00036
CS-00037
( A )
CS-00038