Subaru Legacy 2003 Service Manual page 2535

MANUAL TRANSMISSION AND DIFFERENTIAL
3) After removing ST2, measure starting torque us-
ing torque driver.
ST1 899884100 HOLDER
ST3 899988608 SOCKET WRENCH (27)
Starting torque:
0.3 — 0.8 N·m (0.03 — 0.08 kgf-m, 0.2 — 0.6
ft-lb)
4) If starting torque is not within specified limit, se-
lect new adjusting washer No. 1 and recheck start-
ing torque.
(A) Adjusting washer No. 1
(B) Adjusting washer No. 2
Adjusting washer No. 1
Part No.
803025051
803025052
803025053
803025054
803025055
803025056
803025057
DRIVE PINION SHAFT ASSEMBLY
ST1
ST3
MT-00269
( A )
( B )
MT-00270
Thickness mm (in)
3.925 (0.1545)
3.950 (0.1555)
3.975 (0.1565)
4.000 (0.1575)
4.025 (0.1585)
4.050 (0.1594)
4.075 (0.1604)
5) If specified starting torque range cannot be ob-
tained when a No. 1 adjusting washer is used, then
select a suitable No. 2 adjusting washer from those
listed in the following table. Repeat steps 1)
through 4) to adjust starting torque.
(A) Adjusting washer No. 1
(B) Adjusting washer No. 2
Starting torque
Low
High
Part No.
803025059
803025054
803025058
6) Recheck that starting torque is within specified
range, then clinch lock nut at four positions.
MT-94
( A )
( B )
Dimension H Washer No. 2
Small Select thicker one.
Large Select thinner one.
Adjusting washer No. 2
Thickness mm (in)
3.850 (0.1516)
4.000 (0.1575)
4.150 (0.1634)
MT-00270