Subaru Legacy 2003 Service Manual page 2539

Hide thumbs Also See for Legacy 2003:

Table of Contents

MANUAL TRANSMISSION AND DIFFERENTIAL

4) Install roller bearing to differential case.

• Do not apply pressure in excess of 10 kN (1 ton,

1.1 US ton, 1.0 Imp ton).

• Be careful because roller bearing outer races are

used as a set.

ST1 499277100

BUSHING 1-2 INSTALLER

ST2 398497701

5) Install hypoid driven gear to differential case us-

ing twelve bolts.

Tightening torque:

T: 62 N·m (6.3 kgf-m, 45.6 ft-lb)

(A) Hypoid driven gear

(B) Differential case

FRONT DIFFERENTIAL ASSEMBLY

6) Position drive axle shaft in differential case and

hold it with outer snap ring (28). Using a thickness

gauge, measure clearance between the shaft and

case is within specifications.

It it is not within specifications, replace snap ring

with a suitable one.

0 — 0.25 mm (0 — 0.0098 in)

Snap ring (Outer-28)

2. SIDE RETAINER

1) Install bearing outer race to side retainer.

Press-in while being careful not to scratch side re-

tainer and bearing outer race.

2) Install new oil seal.

ST 499797000

Thickness mm (in)

1.05 (0.0413)

1.20 (0.0472)

Chapters

Table of Contents