Subaru Legacy 2003 Service Manual page 2272

16) Install reduction drive gear. <Ref. to AT-104,
INSTALLATION, Reduction Drive Gear.>
17) Install the center differential carrier. (VTD mod-
el) <Ref. to AT-106, INSTALLATION, Center Differ-
ential Carrier.>
18) Install the extension case and rear vehicle
speed sensor to the transmission case. <Ref. to
AT-86, INSTALLATION, Extension Case.>
19) Insert inhibitor switch and transmission con-
nector into stay.
( B )
(A) Transmission harness
(B) Inhibitor switch harness
20) Install air breather hose. <Ref. to AT-83, IN-
STALLATION, Air Breather Hose.>
21) Install the oil cooler pipes. <Ref. to AT-80, IN-
STALLATION, ATF Cooler Pipe and Hose.>
22) Install the oil charger pipe with O-ring. <Ref. to
AT-84, INSTALLATION, Oil Charger Pipe.>
23) Insert the input shaft while turning lightly by
hand. At this time, not to damage the bushing.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
A
24) Install the torque converter clutch assembly.
<Ref. to AT-85, INSTALLATION, Torque Converter
Clutch Assembly.>
25) Install the transmission assembly to the vehi-
cle. <Ref. to AT-42, INSTALLATION, Automatic
Transmission Assembly.>
LOW AND REVERSE BRAKE
( A )
AT-00174
AT-00291
AT-157
C: INSPECTION
Check for the following.
• Drive plate facing for wear or damage
• Snap ring for wear and spring retainer for defor-
mation
1) Place the same thickness of shim on both sides
to prevent retaining plate from tilting.
2) Inspect clearance and select retaining plate.
Standard value:
0.7 — 1.2 mm (0.028 — 0.047 in)
Allowable limit:
2.2 mm (0.087 in)
Available retaining plates
Part No.
31667AA320
31667AA330
31667AA340
31667AA350
31667AA360
31667AA370
31667AA380
AUTOMATIC TRANSMISSION
AT-00303
Thickness mm (in)
4.1 (0.161)
4.4 (0.173)
4.7 (0.185)
5.0 (0.197)
5.3 (0.209)
5.6 (0.220)
5.9 (0.232)