Subaru Legacy 2003 Service Manual page 2177

AUTOMATIC TRANSMISSION
7) Apply liquid gasket fully to three holes other than
screw holes on transmission case.
Liquid gasket:
THREE BOND 1217B (Part No.
K0877YA020)
8) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
9) Pour ATF into the oil charge pipe.
Recommended fluid:
Dexron III type automatic transmission flu-
id
Fluid capacity:
Fill the same amount of fluid drained from
drain plug hole.
10) Check the level of ATF.
<Ref. to AT-30, Automatic Transmission Fluid.>
CONTROL VALVE BODY
C: DISASSEMBLY
1) Remove oil strainer from lower control valve
body.
NOTE:
Arrange the removed bolts in good order to assem-
ble in the same place as disassembly, because the
bolts length are different.
AT-00052
2) Remove the duty solenoids, solenoids and sen-
sor from the lower valve body.
NOTE:
Arrange the removed bolts in good order to assem-
ble in the same place as disassembly, because the
bolts length are different.
AT-62
C C
C
A
A B
A
A
(A) Short bolt
(B) Middle bolt
(C) Long bolt
( C )
( A )
( G )
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 1 (Yellow)
(E) Shift solenoid 2 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) Sport shift solenoid (Beige) (if equipped)
A
C
A
A
A
B
C C
AT-00065
( D )
( E )
( B )
( H )
( F )
AT-00903