Subaru Legacy 2003 Service Manual page 2203

AUTOMATIC TRANSMISSION
ST3 398663600 PLYER
ST3
2) Remove test pulg.
(A) Extension case
(B) Test plug
3) Remove clutch piston using compressed air.
4) Pay attention, not to bend pipe, and remove
transfer clutch pipe.
5) Remove the dust cover from the extension case.
6) Remove the oil seal from the extension case.
EXTENSION CASE
ST1
ST2
AT-00121
( A )
( B )
AT-00122
AT-00123
AT-00124
AT-88
D: ASSEMBLY
1. MPT MODEL
1) Using the ST and a press, press in a new oil
seal.
ST 498057300 INSTALLER
2) Press in the dust cover.
3) Install the transfer clutch pipe to extension case
without bending pipe.
(A) Extension case
(B) Transfer clutch pipe
4) Install the transfer clutch assembly to the case.
NOTE:
• Be careful not to damage the seal rings.
• Insert the clutch assembly fully into position until
the bearing shoulder bottoms.
( A )
( B )
(A) Transfer clutch
(B) Extension case
2. VTD MODEL
1) Press new oil seal using ST and a press.
ST 498057300 INSTALLER
2) Press dust cover.
( A )
( B )
AT-00120
AT-00125