Subaru Legacy 2003 Service Manual page 2591

CLUTCH SYSTEM
6) Turn the push rod counter clockwise to lengthen
until clutch pedal contacts to stopper bolt or clutch
switch.
7) Turn the push rod further 270× counterclockwise
to lengthen (arrow direction as shown in the figure).
(A)
(A) Accelerator pedal
(B) Clevis
8) Move the clevis pin in lateral direction to ensure
it moves smoothly.
9) Tighten the push rod lock nut.
Tightening torque (Clutch stopper nut):
10 N·m (1.0 kgf-m, 7.2 ft-lb)
10) Measure the full stroke amount of clutch pedal
again.
Specified clutch pedal full stroke: A
130 — 135 mm (5.12 — 5.31 in)
11) Install the clutch switch. <Ref. to CL-40, IN-
STALLATION, Clutch Switch.>
CLUTCH PEDAL
(B)
CL-00101
CL-38
2. RHD MODEL
1) Measure the full stroke amount of clutch pedal.
NOTE:
• Measure the length between seat cushion front
end and center portion of clutch pedal.
• Slide the seat at seventh notch from first notch.
Specified clutch pedal full stroke: A
130 — 135 mm (5.12 — 5.31 in)
A
(A)
(A) Clutch (Ful stroke condition)
(B) Scale
(C) Seat
2) If not as specified, adjust it with stopper bolt or
clutch switch.
Tightening torque (Clutch stopper nut):
8 N·m (0.8 kgf-m, 5.8 ft-lb)
3) Loosen the push rod lock nut.
( D )
( C )
(A) Clevis pin
(B) Snap pin
(C) Push rod
(D) Push rod lock nut
4) Turn the push rod to adjust.
(1) Ensure that the clutch pedal contacts stop-
per bolt, when releasing the clutch pedal.
(C)
(B)
CL-00078
( A )
( B )
CL-00042