Subaru Legacy 2003 Service Manual page 1687

MECHANICAL
12.V-belt
A: REMOVAL
1. FRONT SIDE BELT
NOTE:
Perform the following procedures 1) to 4) with the
engine installed to the body.
1) Remove the V-belt cover.
2) Loosen the lock bolt (A).
3) Loosen the slider bolt (B).
4) Remove the front side belt (C).
(B)
2. REAR SIDE BELT
1) Loosen the lock nut (A).
2) Loosen the slider bolt (B).
3) Remove the A/C belt.
4) Remove the A/C belt tensioner.
V-BELT
(C)
(A)
ME-00059
(B)
(A)
ME-00060
ME-00061
ME(H4DOSTC)-42
B: INSTALLATION
1. FRONT SIDE BELT
CAUTION:
Wipe off any oil or water on the belt and pulley.
1) Install the belt (C), and tighten the slider bolt so
as to obtain the specified belt tension. <Ref. to
ME(H4DOSTC)-43, INSPECTION, V-belt.>
2) Tighten the lock bolt (A).
3) Tighten the slider bolt (B).
Tightening torque:
Lock bolt through bolt:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
Slider bolt:
8 N·m (0.8 kgf-m, 5.5 ft-lb)
(B)
2. REAR SIDE BELT
1) Install the belt, and tighten the slider bolt (B) so
as to obtain the specified belt tension. <Ref. to
ME(H4DOSTC)-43, INSPECTION, V-belt.>
2) Tighten the lock nut (A).
Tightening torque:
Lock nut (A);
22.6 N·m (2.3 kgf-m, 16.6 ft-lb)
(C)
(A)
ME-00059
(B)
(A)
ME-00060