Subaru Legacy 2003 Service Manual page 1752

4. Joint Pipe
A: REMOVAL
1. PRIMARY SIDE
1) Disconnect the ground cable from battery.
2) Remove the under cover.
3) Remove the lower exhaust manifold cover (LH).
4) Remove the nuts which hold front exhaust man-
ifold to joint pipe.
5) Remove the center exhaust pipe. <Ref. to
EX(H4DOSTC)-7, REMOVAL, Center Exhaust
Pipe.>
6) Remove the
IN(H4DOSTC)-15, REMOVAL, Turbocharger.>
7) Take off the joint pipe in the upward direction.
FU-00009
EX-00076
EX-00088
turbocharger. <Ref.
EX(H4DOSTC)-11
JOINT PIPE
2. SECONDARY SIDE
1) Remove the under cover.
2) Remove the lower exhaust manifold cover (RH).
3) Remove the nuts which hold front exhaust man-
ifold to joint pipe.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Replace the gaskets with new ones.
Tightening torque:
T: 35 N·m (3.6 kgf-m, 26.0 ft-lb)
to
EXHAUST
EX-00075
EX-00089