Subaru Select Monitor - Subaru 2003 LEGACY Service Manual

6. Subaru Select Monitor

A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
1) Prepare Subaru Select Monitor kit.
<Ref. to AT-8, PREPARATION TOOL, General De-
scription.>
2) Connect diagnosis cable to Subaru Select Mon-
itor.
3) Insert cartridge into Subaru Select Monitor.
4) Connect Subaru Select Monitor to data link con-
nector.
(1) Data link connector located in the lower por-
tion of the instrument panel (on the driver's
side).
( A )
(A) Data link connector
(2) Connect diagnosis cable to data link con-
nector.
SUBARU SELECT MONITOR
AT-00338
AT-00339
AT-00645
AT-21
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
NOTE:
Do not connect scan tools except for Subaru Select
Monitor and OBD-II general scan tool.
5) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
6) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
7) On the «System Selection Menu» display
screen, select the {Transmission Control System}
and press the [YES] key.
8) Press the [YES] key after displayed the informa-
tion of transmission type.
9) On the «Transmission Diagnosis» display
screen, select the {Diagnostic Code(s) Display}
and press the [YES] key.
10) On the «Diagnostic Code(s) Display» display
screen, select the {Latest Diagnostic Code(s)} or
{Memorized Diagnostic Code(s)} and press the
[YES] key.
NOTE:
• For detailed operation procedure, refer to the
SUBARU SELECT MONITOR OPERATION MAN-
UAL.
• For detailed concerning diagnostic trouble
codes, refer to the DIAGNOSTIC TROUBLE CODE
LIST. <Ref. to AT-29, List of Diagnostic Trouble
Code (DTC).>
2. READ CURRENT DATA
1) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display
screen, select the {Transmission Control System}
and press the [YES] key.
3) Press the [YES] key after displayed the informa-
tion of transmission type.
4) On the «Transmission Diagnosis» display
screen, select the {Current Data Display & Save}
and press the [YES] key.
5) On the «Data Display Menu» display screen, se-
lect the {Data Display} and press the [YES] key.
( A )
AT-00341