Subaru Select Monitor - Subaru B9 TRIBECA WX 2007 Manual

asieps_tobira.book 32 ページ ２０１２年２月１０日 金曜日 午後３時２６分
AIRBAG SYSTEM (DIAGNOSTICS)

7. Subaru Select Monitor

A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
When malfunction of airbag system occurs, the
DTC stored in airbag control module will be read
out.
1) Prepare the Subaru Select Monitor kit. <Ref. to
AB(diag)-8, SPECIAL TOOL, PREPARATION
TOOL, General Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector (1) is located in the low-
er portion of instrument panel (on the driver's
side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor.
4) Turn the ignition switch to ON (engine OFF) and
run the Subaru Select Monitor.
5) On the «Main Menu» display screen, select the
{Each System Check}.
6) On the «System Selection Menu» display
screen, select the {Airbag System}.
7) Select the [OK] after the {**MY AIRBAG SYS-
TEM} is displayed.
8) On the «Airbag System» screen, select the
{DTC Display}.
NOTE:
• For details concerning operation procedure, re-
fer to the "SUBARU SELECT MONITOR OPERA-
TION MANUAL".
• For details concerning DTCs, refer to List of Di-
agnostic Trouble Code (DTC). <Ref. to AB(diag)-
47, List of Diagnostic Trouble Code (DTC).>
Subaru Select Monitor
EN-03693
AB(diag)-32