Siemens SINAMICS G120 List Manual page 388

2 Parameters
2.2 List of parameters
r8962[0...3] PN IP Address Remote Controller 2 / IP Addr Rem Ctrl2
CU240E-2 PN Access level: 3
CU240E-2_PN_F
Can be changed: -
Unit group: -
Min
0
Description: Displays the IP address of the second PROFINET controller connected with the device via PN onboard.
p8980 Ethernet/IP profile / Eth/IP profile
CU240E-2 PN Access level: 3
CU240E-2_PN_F
Can be changed: T
Unit group: -
Min
0
Description: Sets the profile for Ethernet/IP.
Value: 0:
1:
Note: Changes only become effective after POWER ON.
The parameter is not influenced by setting the factory setting.
ODVA: Open DeviceNet Vendor Association
p8981 Ethernet/IP ODVA STOP mode / Eth/IP ODVA STOP
CU240E-2 PN Access level: 3
CU240E-2_PN_F
Can be changed: T
Unit group: -
Min
0
Description: Sets the STOP mode for the Ethernet/IP ODVA profile (p8980 = 1).
Value: 0:
1:
Dependency: Refer to: p8980
Note: Changes only become effective after POWER ON.
The parameter is not influenced by setting the factory setting.
p8982 Ethernet/IP ODVA speed scaling / Eth/IP ODVA n scal
CU240E-2 PN Access level: 3
CU240E-2_PN_F
Can be changed: T
Unit group: -
Min
123
Description: Sets the scaling for the speed for Ethernet/IP ODVA profile (p8980 = 1).
Value: 123:
124:
125:
126:
127:
128:
129:
130:
131:
132:
133:
Dependency: Refer to: p8980
388
SINAMICS
ODVA AC/DC
OFF1
OFF2
32
16
8
4
2
1
0.5
0.25
0.125
0.0625
0.03125
Calculated: -
Scaling: -
Unit selection: -
Max
255
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
133
SINAMICS G120 Control Units CU240B-2/CU240E-2
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
-
Data type: Integer16
Dyn. index: -
Func. diagram: 2473
Factory setting
0
Data type: Integer16
Dyn. index: -
Func. diagram: 2473
Factory setting
0
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
128
List Manual (LH11), 01/2016, A5E33839529