Siemens SINAMICS G120 List Manual page 363

Bit field: Bit
00
01
02
r3978 BICO CounterDevice / BICO CounterDevice
Access level: 4
Can be changed: -
Unit group: -
Min
-
Description: Displays the counter reading for modified BICO interconnections on this device.
The counter is incremented by one for each modified BICO interconnection.
p3981 Faults acknowledge drive object / Faults ackn DO
Access level: 3
Can be changed: U, T
Unit group: -
Min
0
Description: Setting to acknowledge all active faults of a drive object.
Notice: Safety messages cannot be acknowledged using this parameter.
Note: Parameter should be set from 0 to 1 to acknowledge.
After acknowledgment, the parameter is automatically reset to 0.
p3985 Master control mode selection / PcCtrl mode select
Access level: 3
Can be changed: U, T
Unit group: -
Min
0
Description: Sets the mode to change over the master control / LOCAL mode.
Value: 0:
1:
Danger: When changing the master control in operation, the drive can manifest undesirable behavior - e.g. it can accelerate
up to another setpoint.
r3986 Parameter count / Parameter No.
Access level: 3
Can be changed: -
Unit group: -
Min
-
Description: Displays the number of parameters for this drive unit.
The number comprises the device-specific and the drive-specific parameters.
Dependency: Refer to: r0980, r0981, r0989
SINAMICS G120 Control Units CU240B-2/CU240E-2
List Manual (LH11), 01/2016, A5E33839529
Signal name
Software reset active
Writing of parameters disabled as
parameter save in progress
Writing of parameters disabled as macro is
running
Change master control for STW1.0 = 0
Change master control in operation
1 signal
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
1
Calculated: -
Scaling: -
Unit selection: -
Max
-
2 Parameters
2.2 List of parameters
0 signal
No
No
No
Data type: Unsigned32
Dyn. index: -
Func. diagram: -
Factory setting
-
Data type: Unsigned8
Dyn. index: -
Func. diagram: 8060
Factory setting
0
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
0
Data type: Unsigned16
Dyn. index: -
Func. diagram: -
Factory setting
-
FP
-
-
-
363