Siemens SINAMICS G120 List Manual page 382

2 Parameters
2.2 List of parameters
Note: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
For p8807[0...15]:
Dates of installation or first commissioning of the device with the following format options (ASCII):
YYYY-MM-DD
or
YYYY-MM-DD hh:mm
- YYYY: year
- MM: month 01 ... 12
- DD: day 01 ... 31
- hh: hours 00 ... 23
- mm: minutes 00 ... 59
Separators must be placed between the individual data, i.e. a hyphen '-', space ' ' and colon ':'.
p8808[0...53] Identification and Maintenance 3 / I&M 3
CU240E-2 PN Access level: 3
CU240E-2_PN_F
Can be changed: U, T
Unit group: -
Min
-
Description: Parameters for the PROFINET data set "Identification and Maintenance 3" (I&M 3).
This information is known as "Supplementary information".
Dependency: Refer to: p8806, p8807
Notice: Only characters belonging to the standard ASCII character set may be used (32 dec to 126 dec).
Note: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
For p8808[0...53]:
Any supplementary information and comments (ASCII).
p8809[0...53] Identification and Maintenance 4 / I&M 4
CU240E-2 PN Access level: 3
CU240E-2_PN_F
Can be changed: U, T
Unit group: -
Min
0000 bin
Description: Parameters for the PROFINET data set "Identification and Maintenance 4" (I&M 4).
This information is known as "Signature".
Dependency: This parameter is pre-assigned as standard (see note).
After writing information to p8809, p8805 is automatically set to = 1.
Refer to: p8805
Note: For p8805 = 0 (factory setting) the following applies:
Parameter p8809 contains the information described below.
For p8809[0...3]:
Contains the value from r9781[0] "SI change tracking checksum functional".
For p8809[4...7]:
Contains the value from r9782[0] "SI change tracking time stamp checksum functional".
For p8809[8...53]:
Reserved.
r8854 PROFINET state / PN state
CU240E-2 PN Access level: 4
CU240E-2_PN_F
Can be changed: -
Unit group: -
Min
0
Description: State display for PROFINET.
382
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
1111 1111 bin
Calculated: -
Scaling: -
Unit selection: -
Max
255
SINAMICS G120 Control Units CU240B-2/CU240E-2
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
0000 bin
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
-
List Manual (LH11), 01/2016, A5E33839529