Siemens SINAMICS G120 List Manual page 15

Table 2-1
PM230
PM240
PM240-2
PM250
PM260
PM340
Access level
Specifies the minimum access level required to be able to display and change the relevant
parameter. The required access level can be set using p0003.
The system uses the following access levels:
• 1: Standard (not adjustable, included in p0003 = 3)
• 2: Extended (not adjustable, included in p0003 = 3)
• 3: Expert
• 4: Service
Note
Parameter p0003 is CU-specific (belongs to the Control Unit).
A higher access level will also include the functions of the lower levels.
Calculated
Specifies whether the parameter is influenced by automatic calculations.
p0340 determines which calculations are to be performed:
• p0340 = 1 includes the calculations from p0340 = 2, 3, 4, 5.
• p0340 = 2 calculates the motor parameters (p0350 ... p0360, p0625).
• p0340 = 3 includes the calculations from p0340 = 4, 5.
• p0340 = 4 only calculates the controller parameters.
• p0340 = 5 only calculates the controller limits.
Note
For p3900 > 0, p0340 = 1 is also called automatically.
After p1900 = 1, 2, p0340 = 3 is also called automatically.
SINAMICS G120 Control Units CU240B-2/CU240E-2
List Manual (LH11), 01/2016, A5E33839529
Information in the "CU/PM variants" field, continued
CU/PM variants
Power Module for pumps and fans (3 AC 400 V)
Power Module for standard applications with dynamic braking (3 AC 400 V)
Power Module for standard applications with dynamic braking
(1 AC / 3 AC 200 V; 3 AC 400 V; 3 AC 600 V)
Power Module (3 AC 400 V with energy recovery)
Power Module (3 AC 690 V with energy recovery)
Power Module for standard applications with dynamic braking
(1 AC 200 V)
Parameters with this access level are password protected.
2.1 Overview of parameters
Meaning
2 Parameters
15