Content - Siemens SINAMICS G120 List Manual

Legal information
Warning concept
This Manual contains information which you must observe to ensure your own personal safety as well as to avoid
material damage. The notices referring to your personal safety are highlighted in the manual by a safety alert
symbol, notices referring only to equipment damage have no safety alert symbol. Depending on the hazard level,
warnings are indicated in a descending order as follows:
DANGER
indicates that death or serious injury will result if proper precautions are not taken.
WARNING
indicates that death or serious injury could result if proper precautions are not taken.
CAUTION
indicates that minor personal injury can result if proper precautions are not taken.
NOTICE
indicates that property damage can result if proper precautions are not taken.
If more than one level of danger is simultaneously applicable, the warning notice for the highest level is used. A
notice warning of injury to persons with a safety alert symbol may also include a warning relating to property
damage.
Qualified personnel
The product/system described in this documentation may only be operated by personnel qualified for the specific
task in accordance with the relevant documentation for the specific task, in particular its warning notices and safety
instructions. Qualified personnel are those who, based on their training and experience, are capable of identifying
risks and avoiding potential hazards when working with these products/systems.
Proper use of Siemens products
Note the following:
WARNING
Siemens products are only permitted to be used for the applications envisaged in the catalog and in the associated
technical documentation. If third-party products and components are to be used, they must be recommended or
approved by Siemens. These products can only function correctly and safely if they are transported, stored, set up,
mounted, installed, commissioned, operated and maintained correctly. The permissible ambient conditions must be
adhered to. Information in the associated documentation must be observed.
Trademarks
All names identified with ® are registered trademarks of Siemens AG. Any other names used in this publication may
be trademarks whose use by third parties for their own purposes could violate the rights of the owner.
Disclaimer of liability
We have verified that the contents of this document correspond to the hardware and software described. Since
variance cannot be precluded entirely, we cannot guarantee full consistency. The information given in this document
is reviewed at regular intervals and any corrections that might be necessary are made in the subsequent editions.
Siemens AG
Division Digital Factory
Postfach 48 48
90026 NUREMBERG
GERMANY
Document order number: A5E33839529
01/2016 Subject to change
Copyright © Siemens AG 2009 - 2016.
All rights reserved