Siemens SINAMICS G120 List Manual page 108

2 Parameters
2.2 List of parameters
r0052.14 Motor rotates forwards
r0053.0 DC braking active
r0053.1 n_act > p2167 (n_off)
r0053.2 n_act <= p1080 (n_min)
r0053.3 I_act > p2170
r0053.4 n_act > p2155
r0053.5 n_act <= p2155
r0053.6 n_act >= n_set
r0053.10 Technology controller output at the lower limit
r0053.11 Technology controller output at the upper limit
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Note: DO: Digital Output
T: Terminal
Relay output: NO = normally open, NC = normally closed
p0731 BI: CU signal source for terminal DO 1 / CU S_src DO 1
CU240E-2 Access level: 2
CU240E-2_DP
Can be changed: U, T
CU240E-2 PN
Unit group: -
CU240E-2_F
Min
CU240E-2_PN_F
-
CU240E-2_DP_F
Description: Sets the signal source for terminal DO 1 (NO: T. 21).
Recommendation: r0052.0 Ready for switching on
r0052.1 Ready for operation
r0052.2 Operation enabled
r0052.3 Fault present
r0052.4 Coast down active (OFF2)
r0052.5 Quick stop active (OFF3)
r0052.6 Switching-on inhibited active
r0052.7 Alarm present
r0052.9 Control request
r0052.14 Motor rotates forwards
r0053.0 DC braking active
r0053.1 n_act > p2167 (n_off)
r0053.2 n_act <= p1080 (n_min)
r0053.3 I_act > p2170
r0053.4 n_act > p2155
r0053.5 n_act <= p2155
r0053.6 n_act >= n_set
r0053.10 Technology controller output at the lower limit
r0053.11 Technology controller output at the upper limit
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
Note: DO: Digital Output
T: Terminal
Relay output: NO = normally open, NC = normally closed
p0732 BI: CU signal source for terminal DO 2 / CU S_src DO 2
CU240E-2 Access level: 2
CU240E-2_DP
Can be changed: U, T
CU240E-2 PN
Unit group: -
CU240E-2_F
Min
CU240E-2_PN_F
-
CU240E-2_DP_F
Description: Sets the signal source for terminal DO 2 (NO: T. 24 / NC: T. 23).
108
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
SINAMICS G120 Control Units CU240B-2/CU240E-2
Data type: U32 / Binary
Dyn. index: -
Func. diagram: 2119, 2030, 2130
Factory setting
52.7
Data type: U32 / Binary
Dyn. index: -
Func. diagram: 2119, 2030, 2130
Factory setting
52.2
List Manual (LH11), 01/2016, A5E33839529