Show Ip Telnet; Commands In The Global Configuration Mode - Siemens SCALANCE S615 Configuration Manual

6.1.1.7

show ip telnet

Description
This command shows the admin status and the port number of the Telnet server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip telnet
Result
The admin status and the port number of the Telnet server are displayed.
6.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
or
cli#
command to change to this mode.
configure terminal
or
end exit
Network protocols
6.1 IPv4 protocol
command and are then in the
175