Siemens SCALANCE S615 Configuration Manual page 427

Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
event config
{ cold-warmstart | linkchange | authentication-failure | power-change | faultstate-
change | digital-in | vpn-tunnel | all}
{logtable | syslog | email | trap | faults | digital-out | vpn-tunnel | all}
The parameters have the following meaning:
Parameter
cold-warmstart
linkchange
authentication-failure
power-change
faultstate-change
digital-in
vpn-tunnel
all
logtable
syslog
email
trap
faults
digital-out
vpn-tunnel
all
Result
The setting deciding which message of the device is stored or forwarded is configured.
Further notes
You display the status of the events and the clients with the
You delete the settings with the
With this command, the clients are not enabled.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Message if there is cold or warm restart
Message when there is a status change on a physical interface
Message if there is an incorrect login
Message when there is a status change in the power supply
Message when there is a status change in the error monitoring
Message when there is a status change of the digital input
Message when there is a connection change (OpenVPN, IPsec,
SINEMA RC)
All messages
Client that processes the log entries
Client that sends the messages to the log server
Client that sends the e-mails
Client that sends the SNMP traps
Error LED lights up. The setting is possible only for a cold or warm
restart.
Controls the digital output or signals the status change with the
"DO" LED.
Controls the VPN connection (establishment/termination).
All clients at once
command.
no event config
Diagnostics
10.1 Event and fault handling
command.
show events config
427