10.1.9.1
events
Description
With this command, you change to the EVENTS configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
events
Result
You are now in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Further notes
You exit the EVENTS configuration mode with the command
10.1.10
Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
Privileged EXEC mode.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
10.1 Event and fault handling
or
end
command to change to this mode.
events
command, you return to the
exit
command, you return to the
end
Diagnostics
.
exit
423