Snmp Targetaddr - Siemens SCALANCE S615 Configuration Manual

The parameter has the following meaning:
Parameter
NotifyName
Result
The details of the SNMP notifications are deleted.
Further notes
You change the details of an SNMP group with the
You display the configured SNMP notifications with the
You display the configured SNMP target addresses with the
command.
6.6.2.14

snmp targetaddr

Description
With this command, you configure the SNMP target addresses.
Requirement
● The SNMP target parameters are configured.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp targetaddr <TargetAddressName> param <ParamName>
[timeout <Seconds(1-1500)] [retries <RetryCount(1-3)]
[taglist <TagIdentifier | none>]
[port <integer (1-65535)>]
The parameters have the following meaning:
Parameter
TargetAddressName
param
ParamName
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Name of the notification
[{volatile | nonvolatile}]
Description
Name of the target address
Keyword for the parameter name
Name of the destination address or
the designation of the parameter
name
Range of values / note
max. 32 characters
command.
snmp notify
command.
show snmp notif
show snmp targetaddr
{ipv4<IPAddress>}
Range of values
max. 32 characters
-
max. 32 characters
Network protocols
6.6 SNMP
241