No Local-Id - Siemens SCALANCE S615 Configuration Manual

Further notes
You display this setting and other information with the
command.
You remove the local ID with the
9.3.6.6

no local-id

Description
With this command, you remove the local ID.
Requirement
You are in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
Syntax
Call the command without parameter assignment:
no local-id
Result
The local ID is removed.
Further notes
You display this setting and other information with the
command.
You configure the local ID with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
show ipsec conn-authentication
command.
no local-id
show ipsec conn-authentication
command.
local-id
Security and authentication
9.3 IPsec VPN
383