Logon - Siemens SCALANCE S615 Configuration Manual

Functions specific to SCALANCE
3.4 SRS
3.4.3.2

logon

Note
This command is only available with a KEY-PLUG.
Description
With this command you specify which destination server will be used.
Requirement
You are in the SRS configuration mode.
The command prompt is as follows:
cli(config-srs)#
Syntax
Call up the command with the following parameters:
logon {idx <num(1-100)> | all} {enabled|disabled}
The parameters have the following meaning:
Parameter
idx
index
all
enabled
disabled
Result
The specified destination server is enabled.
Further notes
You display this setting and other information with the
You create the destination server with the
You disable the destination server with the
You display the numbers of the destination servers with the
100
Description
Keyword for the number of the destina-
tion server
Number corresponding to a specific
destination server.
Uses all destination servers
Enables the entry
Disables the entry.
logon
no logon (disable)
Range of values / note
-
Enter the required number.
1 ... 100
-
-
show srs overview
command.
command.
logon show-idx
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
command.