Masquerading; No Masquerading - Siemens SCALANCE S615 Configuration Manual

8.1.3.1

masquerading

Description
With this command, you enable the rules for IP masquerading on the interface.
Requirement
● VLAN interface with subnet assignment
● You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call up the command with the following parameters:
masquerading <interface-type> <num(0-4094)>
The parameters have the following meaning:
Parameter
interface-type
num
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The rules for IP masquerading are enabled on the specified interface.
Further notes
You disable IP masquerading with the
You configure the subnet assignment with the
You display the setting with the
8.1.3.2

no masquerading

Description
With this command, you disable the rules for IP masquerading on the interface.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Type or speed of the interface
Number of the addressed VLAN
no masquerading
show masquerading
Range of values / note
Specify a valid interface.
Specify a valid interface
index.
0 ... 4094
command.
command.
map subnet
command.
Layer 3 functions
8.1 NAT
289