Interface - Siemens SCALANCE S615 Configuration Manual

The parameter has the following meaning:
Parameter
longitude
Result
The longitude coordinate is created.
2.1.9.4

interface

Description
With this command, you change to the Interface configuration mode.
There you can edit the settings for one interface. You select the interface with the
parameters of this command. If you specify a logical interface that does not exist, it will be
created. The name of the selected interface is displayed in the command prompt.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
interface{vlan<vlan-id(1-4094>|<interface-type><interface-id>}
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Input box for the longitude coordinate
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Configuration
2.1 System
Range of values / note
max. 32 characters
To use spaces in the entry, enter
the longitude coordinate in
quotes:
coordinates longitude
"123 456"
Values
-
1 ... 4094
Specify a valid interface.
53