Show Ip Telnet; Show Dcp Server - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Call the command without parameters:

show ip gateway

The default gateway is displayed.

show ip telnet

This command shows the admin status and the port number of the Telnet server.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call the command without parameters:

show ip telnet

The admin status and the port number of the Telnet server are displayed.

This command shows whether or not the DCP function is enabled on the device.

If the DCP function is enabled, the read and write permissions are displayed.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Network protocols

7.1 IPv4 protocol