Configuration Save & Restore; Show Running-Config - Siemens SCALANCE S615 Configuration Manual

Configuration
2.4 Configuration Save & Restore
2.4 Configuration Save & Restore
This section describes commands for displaying, saving and restoring configuration settings.
2.4.1

show running-config

Description
This command shows configuration settings of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show running-config [{syslog | dhcp | vlan [ <vlan-id (1-4094)>] |
interface { <interface-type> <interface-id> | vlan <vlan-id(1-4094)> }|
ssh | ssl | ip | snmp | sntp | http | auto-logout | time | ntp | auto-save | events |
firewall | firewallnat | sinemarc | proxyserver | srs}] [all]
The parameters have the following meaning:
Parameter
syslog
dhcp
vlan
vlan-id
interface
interface-type
interface-id
ssh
ssl
ip
snmp
82
or
cli#
Description
Shows the configuration settings of the Syslog
function.
Shows the configuration settings of the Dynam-
ic Host Configuration Protocol.
Keyword for a VLAN connection
Number of the addressed VLAN
Shows that an interface description follows.
Type or speed of the interface
Module no. and port no. of the interface
Shows the configuration settings of the Secure
Shell protocol.
Shows the configuration settings of the Secure
Sockets Layer protocol.
Shows the configuration settings of the Internet
protocol.
Shows the configuration settings of the Simple
Network Management protocol.
Range of values
-
-
-
1 ... 4094
-
Specify a valid interface.
-
-
-
-
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02