Siemens SCALANCE S615 Configuration Manual page 401

Requirement
● The default list is not used.
● You are in the IPSEC PHASE configuration mode.
cli(config-conn-phs2)#
Syntax
Call up the command with the following parameters:
esp-encryption {3des|aes128cbc|aes192cbc|aes256cbc|aes128ctr|aes192ctr|aes256ctr|
aes128ccm16|aes192ccm16|aes256ccm16|aes128gcm16|aes192gcm16|aes256gcm16}
The parameters have the following meaning:
Parameter
3des
aes128cbc
aes192cbc
aes256cbc
aes128ctr
aes192ctr
aes256ctr
aes128ccm16
aes192ccm16
aes256ccm16
aes128gcm16
aes192gcm16
aes256gcm16
x: is supported
-: is not supported
Result
The encryption algorithm is configured.
Further notes
You display this setting and other information with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
The command prompt is as follows:
Description
Triple Data Encryption Standard
Advanced Encryption Standard with 128 bits
Advanced Encryption Standard with 192 bits
Advanced Encryption Standard with 256 bits
Advanced Encryption Standard with 128 bits in Counter mode
Advanced Encryption Standard with 192 bits in Counter mode
Advanced Encryption Standard with 256 bits in Counter mode
Advanced Encryption Standard with 128 bits in Counter mode
using a 16 byte Integrity Check Value (ICV)
Advanced Encryption Standard with 192 bits in Counter mode
using a 16 byte Integrity Check Value (ICV)
Advanced Encryption Standard with 256 bits in Counter mode
using a 16 byte Integrity Check Value (ICV)
Advanced Encryption Standard with 128 bits in Galois Coun-
ter mode using a 16 byte Integrity Check Value (ICV)
Advanced Encryption Standard with 192 bits in Galois Coun-
ter mode using a 16 byte Integrity Check Value (ICV)
Advanced Encryption Standard with 256 bits in Galois Coun-
ter mode using a 16 byte Integrity Check Value (ICV)
Security and authentication
show ipsec conn-phase2
9.3 IPsec VPN
Phase 2
IKEv1 IKEv2
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
x x
command.
401