No Sntp Unicast-Server Ipv4 - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
System time
4.3 SNTP client
4.3.6.3
no sntp unicast-server ipv4
Description
With this command, you delete the attributes for an SNTP unicast server and reset the
address.
Requirement
You are in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
no sntp unicast-server ipv4<ucast_addr>
The parameters have the following meaning:
Parameter
ucast_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The SNTP unicast server is reset to the default value.
Further notes
You configure the setting with the
You display this setting and other information with the
command.
136
Description
Value for an IPv4 unicast address
sntp unicast-server ipv4
Range of values
Enter a valid IPv4 unicast address.
command.
show sntp unicast–mode status
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Hide quick links:
Advertisement
Table of Contents
