Siemens SCALANCE S615 Configuration Manual page 296

Layer 3 functions
8.1 NAT
Requirement
You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call up the command with the following parameters:
no netmap srcint <if-type> [<num(0-4094)>] dstint <if-type> [<num(0-4094)>] idx
<integer(1-200)>
The parameters have the following meaning:
Parameter
srcint
if-type
num
dstint
if-type
num
idx
num
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Result
The specified NETMAP rule is deleted.
Further notes
You display the numbers of the NETMAP rules with the
You delete all NETMAP rules with the
You create a NETMAP rule with the commands
destination type ipv4
296
Description
Keyword for the source interface
Type or speed of the interface
Number of the addressed interface
Keyword for the destination interface
Type or speed of the interface
Number of the addressed interface
Keyword for the number of the NETMAP rule
Number corresponding to a specific NETMAP
rule.
no netpmap all
.
Range of values / note
-
Specify a valid interface.
0 ... 4094
-
Specify a valid interface.
0 ... 4094
-
Specify a valid number.
0 ... 200
netmap show-idx
command.
netmap source type ipv4
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
and
netmap