Interface Identifiers And Addresses; Naming Interfaces - Siemens SCALANCE S615 Configuration Manual

1.5

Interface identifiers and addresses

1.5.1

Naming interfaces

Addressing interfaces
The device has several types of interface that are addressed in different ways:
Addressing physical interfaces
This notation also applies to other commands that address an Interface.
● Enter the command "
● Specify the interface type
● After a space, enter the interface identifier,
The interface identifier is made up of the module number and the port number separated
by a slash. The interfaces permanently installed in the device are identified with module
0.
Example:
Fast Ethernet:
Addressing logical interfaces
This notation also applies to other commands that address a logical interface.
● Enter the command "
● Enter the keyword for the VLAN interface.
● After a space, enter the number of the VLAN interface you assigned when you created it.
Example:
VLAN 2:
Available physical interfaces
Device
S615
Available logical interfaces
● VLAN
The device supports up to 16 virtual networks.
To be able to use a VLAN, create it with the
Configuring an interface in the Interface configuration mode
To configure the interface use the command
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
interface
<interface-type>
interface fa 0/1
interface
interface vlan 2
Interfaces interface-type
fa: fast-
5 x Fast Ethernet
ethernet
1.5 Interface identifiers and addresses
".
.
<interface-id>
".
interface-id
X = 1 .. 5
command.
vlan
in the global configuration mode.
interface
Description
.
fa 0/X
25