Ipv4Rule Set Action - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.2 Firewall
9.2.4.11

ipv4rule set action

Description
With this command, you change the action taken with incoming IPv4 packets.
Requirement
● The IPv4 firewall rule has been created.
● You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
ipv4rule idx <number(1-100)> set action {drop|acc|rej}
The parameters have the following meaning:
Parameter
idx
number
action
acc
drop
rej
Result
The action taken with the corresponding IPv4 firewall rule has been changed.
Further notes
You display this setting and other information with the
command.
You obtain the numbers with the
324
Description
Keyword for index
Number corresponding to a spe-
cific IPv4 rule.
Keyword for the action with in-
coming IPv4 packets
The data packets can pass
through.
The data packets are discarded
without any notification to the
sender.
The data packets are rejected,
and the sender receives a corre-
sponding message.
ipv4rule show-rules
Range of values / note
-
Enter the required number.
1 ... 100
-
-
-
-
show firewall ip-rules ipv4
command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02