Addr - Siemens SCALANCE S615 Configuration Manual

9.3.4.1

addr

Description
With this command, you configure the address of the VPN remote station.
Requirement
You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call up the command with the following parameters:
addr <subnet|dns>
The parameters have the following meaning:
Parameter
subnet
dns
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The address is specified.
Further notes
You configure the mode with the
You display this setting and other information with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
IP subnet
DNS host name
conn-mode
Security and authentication
Range of values / note
In Roadwarrior mode
•
Specify the WAN IP address.
In standard mode
•
Enter an IP range from which connections will be
accepted.
0.0.0.0/0 means all IP addresses are accepted.
Only in standard mode
Specify the DNS host name.
command.
show ipsec remoteend
9.3 IPsec VPN
command.
367