Ip Address - Siemens SCALANCE S615 Configuration Manual

5.1.4.1

ip address

Description
With this command, you assign an IP address.
Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip address <ip-address> {<subnet-mask>| / <prefix-length(0-32)>}
The parameter has the following meaning:
Parameter
ip-address
subnet-mask
prefix-length
For information on names of addresses and interfaces, refer to the section "Auto-Hotspot".
Result
The IP address is assigned.
Note
Effectiveness of the command
The command is effective immediately. If you configure the interface via which you access
the device, the connection will be lost!
Further notes
You delete the setting with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
IP address
Subnet mask
Decimal representation of the mask as
a number of "1" bits
command.
no ip address
Network structures
5.1 VLAN
Range of values / note
Specify a valid IP address.
Enter a valid subnet mask.
0 ... 32
163