Commands In The Interface Configuration Mode; Ip Address - Siemens SCALANCE S615 Configuration Manual

Result
The Telnet server is disabled.
Further notes
You enable the Telnet server with the
6.1.3

Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
6.1.3.1

ip address

Description
With this command, you assign an IP address to a VLAN interface.
Requirement
You are in the Interface configuration mode of VLAN or a router port and DHCP was
disabled with the
The command prompt is as follows:
cli(config-if-vlan$)#
or with a router port:
cli(config-RPort-if-Int$-$)
Syntax
Call up the command with the following parameters:
ip address <ip-address> {<subnet-mask>|/<prefix-length(0-32)>}[secondary]
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
telnet-server
command.
no ip address
command.
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
Network protocols
6.1 IPv4 protocol
183