Negotiation; No Negotiation - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
Configuration
2.1 System
2.1.10.7
negotiation
Description
With this command, you enable autonegotiation of connection parameters on an interface.
Autonegotiation must be set for every interface of connected interfaces.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
negotiation
Result
The automatic negotiation of connection parameters on an interface is activated.
Further notes
You disable the autonegotiation of connection parameters with the
command.
2.1.10.8
no negotiation
Description
With this command, you disable autonegotiation of connection parameters on an interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no negotiation
64
no negotiation
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Hide quick links:
Advertisement
Table of Contents
