Show Vlan Port Config - Siemens SCALANCE S615 Configuration Manual

5.1.1.5

show vlan port config

Description
This command shows the VLAN-specific information for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show vlan port config[{port<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.
Result
The information about the ports is displayed.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
or
cli#
Description
Keyword for a port
Type of interface
Module no. and port no. of the interface
Network structures
5.1 VLAN
Range of values / note
-
Enter a valid interface.
143