No Aggressive - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
Security and authentication
9.3 IPsec VPN
Syntax
Call the command without parameter assignment:
aggressive
Result
The setting is configured.
Further notes
You display this setting and other information with the
You disable the aggressive mode with the
9.3.7.2
no aggressive
Description
With this command, you disable the aggressive mode.
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call the command without parameter assignment:
no aggressive
Result
The setting is disabled. The main mode is used.
Further notes
You display this setting and other information with the
You enable the aggressive mode with the
386
show ipsec conn-phase1
command.
no aggressive
show ipsec conn-phase1
command.
aggressive
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
command.
Hide quick links:
Advertisement
Table of Contents
