Siemens SCALANCE S615 Configuration Manual page 50

Configuration
2.1 System
Syntax
Call up the command with the following parameters:
ping [ip]<destination-address>
The parameters have the following meaning:
Parameter
ip
destination-
address
size
byte
count
packet_count
timeout
seconds
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameters from the parameter list, the default values are used.
At system start or when using the
following defaults apply:
Parameter
size
count
time-out
Result
The messages relating to the response of the called node are displayed.
50
[size<byte(0-2080)>]
[count<packet_count(1-10)>]
[timeout<seconds(1-100)>]
Description
Uses an IP address
Address of the called node
Keyword for the size of the packets to be
transferred
Keyword for the size of the packets in bytes 0 ... 2080
Keyword for the number of packets to be
requested
Number of packets
Response wait time
If this time expires, the request is reported
as "timed out".
Time to the timeout in seconds
command with the option
restart
Default value
32
3
1
Configuration Manual, 06/2015, C79000-G8976-C406-02
Range of values
-
Enter a valid IP address or a valid
hostname.
-
-
1 ... 10
-
1 ... 100
or
memory factory
SCALANCE S615 Command Line Interface
, the