Functions specific to SCALANCE
3.5 SINEMA RC
You exit the Global configuration mode with the
Privileged EXEC mode again.
3.5.3.1
sinemarc
Note
This command is only available with a KEY-PLUG.
Description
With this command, you change to the SINEMARC configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
sinemarc
Result
You are now in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Further notes
You exit the SINEMARC configuration mode with the
3.5.4
Commands in the SINEMARC configuration mode
This section describes commands that you can call up in the SINEMARC configuration
mode.
110
or
command and are then in the
end
exit
or
command.
end
exit
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02