Show Ip Routing; Show Ip Static Route - Siemens SCALANCE S615 Configuration Manual

Network protocols
6.1 IPv4 protocol
6.1.1.5

show ip routing

Description
This command shows whether or not the "routing" function is enabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip routing
Result
The routing function is enabled.
6.1.1.6

show ip static route

Description
This command shows the routes that were generated statically.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip static route
Result
The static routes are displayed.
174
or
cli#
or
cli#
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02