Device Id - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
Functions specific to SCALANCE
3.5 SINEMA RC
3.5.4.4
device id
Note
This command is only available with a KEY-PLUG.
Description
With this command, you configure the device ID. The device ID is assigned when configuring
the device on the SINEMA RC Server. You will find further information on this in the
Operating Instructions of the SINEMA RC Server.
Requirement
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call the command without parameter assignment:
device id <number(0-20000)>
Syntax
Call up the command with the following parameters:
device id <number(0-20000)>
The parameter has the following meaning:
Parameter
number
Result
The device ID is configured.
Further notes
You display this setting and other information with the
114
Description
Device ID
Range of values / note
Enter the device ID.
0 ... 20000
command.
show sinemarc
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Hide quick links:
Advertisement
Table of Contents
