Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call the command without parameter assignment:
dpd
Result
DPD is enabled. Using DPD, it is possible to find out whether the VPN connection still exists
or whether it has aborted.
Further notes
You display this setting and other information with the
You disable DPD with the
9.3.7.6
no dpd
Description
With this command, you disable DPD.
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call the command without parameter assignment:
dpd
no
Result
DPD is disabled.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
no dpd
Security and authentication
show ipsec conn-phase1
9.3 IPsec VPN
command.
389