Security and authentication
9.3 IPsec VPN
9.3.5.6
phase
Description
With this command, you change to the IPSEC PHASE configuration mode.
Requirement
You are in the IPSEC CONNECTION configuration mode.
The command prompt is as follows:
cli(config-conn-X)#
Syntax
Call up the command with the following parameters:
phase <num(1-2)>
The parameter has the following meaning:
Parameter
num
Result
You are now in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phsX)#
Further notes
You display this setting and other information with the
9.3.5.7
timeout
Description
With this command, you configure the interval after which the VPN connection will be
terminated. If no packets are sent during this time, the VPN connection is automatically
terminated.
376
Description
Phase of the VPN connection
Range of values / note
1: Phase 1
•
2: Phase 2
•
show ipsec connections
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.