Vlan - Siemens SCALANCE S615 Configuration Manual

5.1.2.10

vlan

Description
With this command, you create a VLAN on the device and change to the VLAN configuration
mode.
Note
The device supports up to 24 virtual networks.
In the provider backbone bridge mode, this command is used to create user, service and
backbone VLANs.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameters
vlan-id
Do not enter any leading zeros with the number of the VLAN.
Result
The VLAN is created.
You are now in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Further notes
You delete the VLAN with the
You can display information about the VLAN with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Number of the addressed VLAN
command.
no vlan
Network structures
Range of values
1 ... 4094
command.
show vlan
5.1 VLAN
153