Show Ip Interface; Show Versions - Siemens SCALANCE S615 Configuration Manual

Configuration
2.1 System
2.1.1.10

show ip interface

Description
This command shows the configuration of one, several or all IP interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip interface
}]
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-
type
interface-id
loopback
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available IP interfaces.
Result
The configuration of the selected IP interface is displayed.
2.1.1.11

show versions

Description
This command shows the versions of the hardware and software of the device.
44
or
cli#
[{
vlan <vlan-id(1-4094)> |
<interface-type> <interface-id> |
loopback
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Loopback
Range of values / note
-
1 ... 4094
Enter a valid interface.
-
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02