Network structures
5.1 VLAN
5.1.3.6
no switchport
Description
With this command you configure the interface as a router port. This disables all switching
and layer 2 functions.
Requirement
● The Interface is shut down.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport
Result
The interface is configured as a router port. Activate the interface again.
Further notes
You shut down the interface with the
You activate the interface with the
You configure the interface as a switch port with the
You display the status of this function and other information with the
interface
160
command.
command.
shutdown complete
command.
no shutdown
switchport
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
show
SCALANCE S615 Command Line Interface