Commands In The Ipsec Authentication Configuration Mode; Auth Cacert - Siemens SCALANCE S615 Configuration Manual

9.3.6

Commands in the IPSEC AUTHENTICATION configuration mode

This section describes commands that you can call up in the IPSEC AUTHENTICATION
configuration mode.
In the IPSEC configuration mode, enter the
mode.
● If you exit the IPSEC AUTHENTICATION configuration mode with the
you return to the IPSEC configuration mode.
● If you exit the IPSEC AUTHENTICATION configuration mode with the
return to the Privileged EXEC mode.
9.3.6.1

auth cacert

Description
With this command you specify that a CA certificate will be used for authentication.
Requirement
● The certificates are loaded.
● You are in the IPSEC AUTHENTICATION configuration mode.
cli(config-conn-auth)#
Syntax
Call up the command with the following parameters:
auth cacert <string(255)> localcert <string(255)>
The parameters have the following meaning:
Parameter
cacert
string
localcert
string
Result
The setting is configured.
Further notes
You show the loaded certificates with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
The command prompt is as follows:
Description
Keyword for CA certificate
Name of the CA certificate
Keyword for a device certificate
Name of the device certificate
command to change to this
authentication
Range of values / note
Specify a valid CA certificate.
Specify a valid device certificate.
command.
show-idx
Security and authentication
9.3 IPsec VPN
command,
exit
command, you
end
379