Dpd-Period - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.3 IPsec VPN
Further notes
You display this setting and other information with the
You enable DPD with the
9.3.7.7

dpd-period

Description
With this command, you configure the period after which DPD queries are sent.
Requirement
● DPD is enabled
● You are in the IPSEC PHASE configuration mode.
cli(config-conn-phs1)#
Syntax
Call up the command with the following parameters:
dpd-period <sec(10-120)>
The parameter has the following meaning:
Parameter
sec
Result
The period of time is configured.
Further notes
You display this setting and other information with the
You enable DPD with the
390
dpd
The command prompt is as follows:
Description
Period for DPD queries
dpd
command.
command.
Configuration Manual, 06/2015, C79000-G8976-C406-02
show ipsec conn-phase1
Range of values / note
Enter the period of time in sec-
onds.
show ipsec conn-phase1
SCALANCE S615 Command Line Interface
command.
command.